On rebuild of...
50 results in 0.0056 seconds.
-
Refurbishment of a pawl unit - these get very little notice or attention
Refurbishment of a pawl unit - these get very little notice or attention
On rebuild of...Last edited by John A. Ross; 24 June 2020, 08:27 PM. -
Difference in early Mk 1 and M2 Dash Panels Hillman Imp
A common question as regards Imp Dash and often cause for confusion
So just adding a note... -
Custom floor mats - the forgotten necessity for your carpets
And something I was looking at the other day and was just highlighted over at The Imp Club Forum...
Last edited by John A. Ross; 19 May 2020, 09:19 PM. -
Wiper wheel boxes old NOS and other fit and diffrences
Just posting a note about the new wheel boxes supplied by Bob at Club Spares.
These do... -
Clutch roller release bearing
Bast cleaned clutch fork, strengthened and modified to accept a roller release bearing with a proper... -
BRU 434B And the Journey Begins - First Engine Removal and more
Hi all,
Firstly hope you are all well and staying safe!?
As... -
Handmade special tools we make - rear drive shaft pusher / crank pulley puller
Hand made special tools we end up making
Rear drive shaft pusher as drive shafts always... -
Competition Gear box mounts
Competition Gearbox Mounts by Mike Dent aka moose
Motorsport tried and proven.
... -
Thread sizes, nut sizes, spanner sizes and UNC/UNF TPI
Not an exhaustive list and not Imp Specific but a quick reference
... -
Boot interior card
On mine as well as many other cars the centre card boot trim that sits on the tank and also goes up...
-
Remade the rear numberplate
Rear numberplate restoration / alteration done .
Digits are original to the car ( Hills... -
When turbos go wrong - Paul Turbo Conroy at it again
When turbos go wrong - Paul Turbo Conroy at it again
Pictures say it all, no words, just... -
RG.374 - Clutch Plate Centraliser - Clutch Alignment Tool
Again not an essential tool but certainly a big help
Images to follow once weather breaks... -
Not a step by step or a how-too but a real view (not from a manual) engine rebuild.
First clean clean clean, every part from top to toe. Assume he head has already been done as those are...
Last edited by John A. Ross; 14 February 2020, 09:50 PM. -
Who has fitted Franks Manifolds - Pictures of items and installation would be good
Who has fitted Franks Manifolds - if anyone has images and installation experiences they want to share...
