Next job up - VB6 upgrade
The next generation of forum software from VB, OK its been out...
41 results in 0.0026 seconds.
-
Merry Christmas to one and all !
Merry Christmas to one and all !
Wishing you all a very happy new year when it comes around... -
Imp gauges again how they work and how to test them
Well Imp gauges are not a mystery, nor are they truly electronic devices, quite the opposite they are...Last edited by John A. Ross; 25 June 2024, 09:58 AM. -
And while we wait for other things to flash off
I did one side of these yesterday and the other today as I had limited time.
One of thes... -
Drivers Side Rear Suspension Mount And Inner Wheel Tub Repair
Was bitter cold this mortning, so the grump was on from the get go !
... -
Imp anatomy take 3 Floors rear crossmeber and rear spring cones / supports
A closer up view of one rotten floor, seen worse though
Then along to the rear crossmember... -
Look after yer nuts and bolts
Take a look at this and see why clean threads and lubrication are essential on nuts and bolts. This...Last edited by John A. Ross; 30 November 2022, 11:12 AM. -
Useless info
Il try and do a few of these but heres the first
Early cars had a Lucas 2ST starter solenoid... -
Considering a new wiring harness for your Imp, nothing to fear !
I have had now 2 requests in the last week as regards making wiring harnesses for the Imp so I have...
Last edited by John A. Ross; 27 February 2022, 12:35 PM. -
Inside 1150cc hillman imp engine and dyno test, ( dyno over reads 10-15hp)
Last edited by John A. Ross; 13 February 2022, 09:54 PM. -
Hillman imp turbo special saloon engine
Dyno test engine for special saloon imp Cscc
Andy jones...Last edited by John A. Ross; 10 December 2021, 07:38 PM. -
Dreamy
The Dreamy Official ???????????????? What's that all about? shall l need to get my crayons out? -
Suns up, wakey time :-)
Wakey time
DDG taking advantage of the sun this week, cold but workable.... -
Front wheel bearing part numbers
Cheers for the tip Mike moose549 ...Last edited by John A. Ross; 1 November 2021, 08:33 PM. -
ork on Karl's #singerchamois ithe tricky bits gutter rails front pillar
Work on Karl's #singerchamois is now nearing the end all the tricky bits on the gutter rails and drivers...
Last edited by John A. Ross; 9 October 2021, 10:53 AM.